Spedisci un articolo
Risparmia CHF 1.60
Messaggi

Peavey 400 Series Bass Amp Head 1977

800.-

15.11.2026
Strumenti
Ticino
6963, Pregassona
READ THE FULL DESCRIPTION!

Legendary Peavey 400 bass head 220 volt version. This is the MK1 model, manufactured in 1977; there is an internal stamp dating its quality control check to February 14, 1977.

This head features a channel with built-in distortion and fuzz, a parametric equalizer, and the ability to run the two channels (clean and drive) in either series or parallel.

Unlike many similar heads on the market, this unit has been serviced and had its main electrolytic capacitors replaced with top-tier components (such as TAD, F+T, etc.).

It is an amplifier that is ready to play immediately, requiring no further work.

Highly sought-after for genres such as Stoner, Doom, Sludge, etc...

PEAVEY "THE BASS" 400 SERIES (Mid-1970s)

Manufacturer: Peavey Electronics (USA)

Production Period: Approx. 19741977

Technology: Solid State

Output Power:

200 Watts RMS into a minimum 2-Ohm load

Approx. 130140 Watts RMS into a 4-Ohm load

Channels: 2 blendable channels (Normal / Harmonics)

PREAMP SECTION AND CONTROLS

Channel 1 (Normal / Clean):

Controls: Volume, Bass, Middle, Treble (Passive EQ)

Channel 2 (Harmonics / Distortion):

Controls: Volume, Distortion, Fuzz, Slope (Resonance/Bass-boost)

Integrated Equalizer:

6-band active Graphic EQ (±14 dB)

Assignment: Factory-configured to affect only the Harmonics channel (when used in separate channel mode) or the combined signal (in Series mode)

FRONT PANEL INPUTS (Automix System)

Normal Input: Independent clean channel

Harmonics Input: Independent distorted channel

Parallel Input: Splits the signal, sending it to both channels simultaneously (allows blending clean and distorted tones to preserve low frequencies)

Series Input: Sends the signal to the Normal channel (acting as a booster) before it enters the Harmonics channel (maximum gain and sustain) Fuzz)

REAR PANEL AND CONNECTIONS

Speaker Outputs: Two 1/4" jack outputs wired in parallel (Minimum total impedance: 2 Ohms)

Line Outputs: Booster Out (1V RMS pre-amplified output for external power amps)

Footswitch Input: Remote Switch Jack (allows remote control of distortion and graphic EQ)

PHYSICAL SPECIFICATIONS

Chassis: Black Tolex-covered wooden housing, protective metal corners, brushed aluminum front panel.
Prezzo CHF
800.-
CAP
6963
Spedizione disponibile
Sì
Condizione
Usato

david6016

Attivo dal 24.11.2014

6963, Pregassona
Tutti gli annunci

Annunci simili

  • Peavey Bass Amp Mark III Series 400B 300W Late 1970s
    Peavey Bass Amp Mark III Series 400B 300W Late 1970s
    700.-
  • Peavey Blues Classic 50 combo 1x15" USA
    Peavey Blues Classic 50 combo 1x15" USA
    590.-
  • Laney TT50H 50w EL34 all tube amp original footswitch 2000
    Laney TT50H 50w EL34 all tube amp original footswitch 2000
    400.-
  • BOSS AD-8 Acoustic Guitar Processor
    BOSS AD-8 Acoustic Guitar Processor
    160.-
  • BRBS 100 Deluxe 3 Plus
    BRBS 100 Deluxe 3 Plus
    3 000.-
  • Mesa Boogie triple rectifier 150W Head
    Mesa Boogie triple rectifier 150W Head
    1 280.-
  • Mezzabarba MZero Overdrive Eric Steckel Head
    Mezzabarba MZero Overdrive Eric Steckel Head
    2 500.-
  • Boss GE-7 Equalizzatore Grafico
    Boss GE-7 Equalizzatore Grafico
    75.-
  • Testata Randall RM-100
    Testata Randall RM-100
    2 000.-
  • RegistratiAiutoContattoJobsMediaConsigli per la sicurezza

    Servizi

    Note legali

    CondizioniImpostazioni sulla privacyProtezione dei dati

    © SMG Swiss Marketplace Group AG 2026.

    La duplicazione e la ripresa degli annunci da parte di terzi, in particolare di foto e dati personali in essi contenuti, viola i diritti ad essi associati ed è espressamente vietate.