Toutes les annonces de Tieftöner
Actif depuis 24.02.2012
4 annonces
Trier selon
Plus récentes
Wohlen b. Bern, 3033, 08.09.2026
Broughton Audio SV-Pre JFET Preamplifier Basspedal
Broughton Audio SV-Pre JFET Preamplifier, Handmade in Canada
Absolut neuwertiges Basspedal für die analoge Emulation eines Ampeg SVT Sound.
The SV-Pre is a JFET preamplifier that has been modeled after the preamp section of the 70s SVT. Each gain stage has been carefully designed to capture the feel of warmth and breakup found on the original amp. Coupled with a cab sim, you could have the monstrous tone of the classic bass amp stack without the challenge of transporting 250 pounds of gear.
In addition to the gain stage design, the EQ and tone switches have been designed to give the same response as those on the original amp. The Bass and Treble controls are the standard James stack configuration, having a shelving response of the lows and highs. The eq is flat when at noon.
The middle control uses a simulated inductor to emulate the same frequency response and width of the mid control on the SVT. Instead of three fixed frequencies, the frequency knob continuously varies from 220 to 3k Hz. The mid eq is flat when at noon.
The Low toggle switch uses the same circuitry as the three-way Ultra lo switch on the SVT. With the toggle to the right, a 2-pole high pass filter is applied, and allows for a more natural drive tone. With the toggle in the middle position, the low end is unaffected. With the toggle in the left position, a slight scoop is applied, emphasizing deep lows and treble frequencies. The Bright toggle switch applies a treble boost, and is more pronounced at lower gain settings.
A Master volume knob has been added on the output to set the overall level. Use the Gain knob to set the desired amount of warmth and overdrive. The Gain knob is equivalent the the Volume knob on the 70s SVT.
The pedal requires a DC power supply (not included). The DC supply should be a standard Boss style connector, center negative polarity. The pedal can accept 9 to 24 volts . The current draw is approximately 20 mA.
The SV-Pre has a true bypass switch.
Dimensions: 4.77" long x 2.6" wide
150.-
Wohlen b. Bern, 3033, 08.09.2026
Broughton Audio Fliptop JFET Preamplifier Basspedal
Broughton Audio Fliptop JFET Preamplifier, Handmade in Canada
Absolut neuwertiges Basspedal für die analoge Emulation eines Ampeg Potraflex B15 Sound.
The Fliptop is a JFET preamplifier that is modeled after the B15 amplifier. The gain staging and EQ sections were carefully designed to give the feel and response of the vintage tube amp, offering a good range of pillowy tone that can be driven to the point of light overdrive if pushed.
In addition to the James stack EQ and gain staging, the Fliptop adds a Master volume control on the output so you can dial in the amount of drive you want while adjusting the volume as needed.
The Cab knob is essentially a wet/dry control, allowing you to apply 0 to 100% of the cab tone to the preamplifier output. Dialing in more of the cab response tightens the low end and cuts the high frequencies for a warm, vintage tone. The frequency response is modelled after the 15" cab.
The pedal requires a 9V DC power supply (not included). The DC supply should be a standard Boss style connector, center negative polarity. The current draw is approximately 12 mA. The power supply may be increased up to 24V DC with the result of more clean headroom and a slight increase in boost.
The Fliptop has a true bypass switch.
Dimensions: 4.77" long x 2.6" wide
150.-
Wohlen b. Bern, 3033, 07.09.2026
Fender American Deluxe Jazz Bass 5 mit Sadowsky Preamp
Fender American Deluxe Jazz Bass 5-string mit Sadowsky Preamp und Lindy Fralin Pickups
Sehr guter und fast neuwertiger Zustand ohne Beschädigungen oder Defekte. Der Bass ist 4,3 kg leicht und spielt sich dank dem compound neck angenehm ergonomisch. Die originale Fender Elektronik wurde professionell durch einen Sadowsky-Preamp ersetzt, die Fender Noiseless Pickups durch neue Lindy Fralin Vintage Single-Coils ausgewechselt. Auf Grund der Pickup und Preampkonfiguration ist der Sound am ehesten mit einem Sadowsky Bass zu vergleichen. Bespielbarkeit, Qualität und Sound sind fantastisch!
Model: Fender American Deluxe Jazz Bass V
Manufactured: Made in Corona USA
Finish: Natural Polyurethane gloss
Body: Premium Ash Body
Pickguard: Three-Ply Black Pickguard
Neck: Maple Neck, Modern C
Neck Binding: Black Plastic
Fingerboard: Maple, 9.5" to 14" Compound Radius
Frets: 21, Medium Jumbo
Nut: 1.875" (47.6 mm) Bone
Position Inlays: Black Block Inlays
Side Dots: Black Clay Dots
Pickups: Lindy Fralin Single-Coils
Controls: vol, pan, bass boost, treble boost and vintage tone control
Electronics: Sadowsky active 2-band preamp with VTC
Bridge: Hi-Mass Vintage Bridge (String-Through-Body or Top-Load)
Tuning Machines: Lightweight Vintage-Style with Tapered Shafts
Neck Plate: Fender Deluxe 5-Bolt
Special Features: Posiflex Graphite Neck Support Rods
Case: Fender Deluxe Hardshell Case
Privatverkauf, ohne Garantie, keine Rücknahme oder Gewährleistung.
Besichtigung und Antesten in der Region Bern nach Voranmeldung möglich.
Kein Versand, keine Teilzahlung, Barzahlung bei Abholung oder via TWINT.
Bitte keine best-price Anfragen und keine Eintausch-Angebote!
1 900.-
Wohlen b. Bern, 3033, 10.08.2026
Ampeg Portaflex PF-50T Vollröhren Basshead, inkl. Flightcase
Ampeg Portaflex PF-50T Vollröhren Basshead, inkl. Flightcase
Der klassische fette Vollröhrensound von Ampeg in einem kompakten Paket, inklusive Transportcase.
Ideal als professionelle Vollröhren-Recording-Lösung für das Studio oder einfach als kompakter Übe- und Session-Amp mit erstklassigen Röhrensounds. Kein Lautsprecher bzw. Last erforderlich.
Guter aber gebrauchter Zustand ohne Beschädigungen oder Defekte.
Privatverkauf, ohne Garantie, keine Rücknahme oder Gewährleistung.
Besichtigung und Antesten in der Region Bern nach Voranmeldung möglich.
Kein Versand möglich, nur Abholung, keine Teilzahlung, Barzahlung bei Abholung oder via TWINT.
Bitte keine best-price Anfragen und keine Eintausch-Angebote!
Bauform: Topteil im Metallgehäuse
Technik: Röhre
Röhrenbestückung: 2 x 6L6, 2 x 12AX7, 1 x 12AU7
Maße: 38 x 25 x 18 cm (BxTxH)
Gewicht: 9 kg (15 kg incl. case)
Klangregelung: 3-Band EQ, parametr. Mittenregelung, Ultra Hi/Lo
Ausgänge: Preamp XLR / Transformer Balanced XLR
Leistung: 50 Watt an 4 oder 8 Ohm
900.-